Manufacturing

Wood Structure technological flow

Like any technological process, the cutting of materials follows automatically after the design.

The jointing of the wooden elements that make up the beam with the industrialised lattice is made with the help of the multi-nail connectors. The multi-nail boards are made of a special steel, by stamping, obtaining sharp teeth on one side. The assembly of the knots from the lattice is done with the help of a specialised press, pressing the multi-nail board on both sides with a force of 20-50 tons, depending on the type of board and the section of wood used. In this way, the pressing is done uniformly, the use of the hammer being forbidden.

The prefabricated floors of Posi-Strut lattices can replace the classic concrete floors from the last level. It is sufficient to apply a 20 mm OSB board, a protective film and a screed of maximum 4 mm and the floor behaves like the concrete one from all points of view.

Benefits:
Easy to mount, light weight
You can insert all the installations inside
Low costs

The machines used on the technological flow

Wood material impregnation tank

  • Length from 6 to 16 m
  • Protecting the environment by using the lift system
  • Safety cover against contamination
  • Double layer of metal frame stiffened with metal beams
  • The thickness of the inner material (plate) is 5 mm and the outer thickness 3 mm
  • Two separate chambers

Easycut 828 FR cutting circular

 

The Easy Cut circular is a single-blade, numerically controlled circular, designed for cutting wood for beams with lattices.

  • Thanks to the two motorised tables fixed in the lateral parts of the circular, the movement of the wood towards the circular blade and the evacuation is done efficiently and without effort.
  • Friendly, intuitive interface.
  • Computer operating system Windows, easily controlled using the touch screen.

Mark 1 Light 4M press

 

MARK-1 Light is a lightweight, fully automatic press with continuous metal table.

  • It has the possibility to press manually or completely automatically, recognises the files generated by the design program.
  • Large pressing surface.
  • Pressing force of 30 tons
  • It has a fluid, continuous and very silent movement.
  • Allows simultaneous pressing of several types/models of farms.
  • Operating mode: fully automatic, with manual or manual storage.
  • Width of 4 m and length of 2.2 m

POSI – STRUT manual press for beams

 

  • Manual operation mode with 2 hydraulic cylinders
  • Manually move of the pressing head along the table
  • Pressing force between 15 and 30 tons

Butterfly table for the manufacture of wooden walls

The butterfly table is an average productivity line designed for the manufacture of walls in framing wood houses. This installation represents the most efficient solution in the manufacture of high quality walls, which helps to increase the efficiency and productivity, including the final cost of the entire wooden house.
The butterfly table consists of 2 tables, a main table and a secondary table.
The alignment (calibration) of the wooden wall bottoms is performed with the pneumatic system provided with the main table so that the effect of decalibration will be eliminated completely resulting in a perfect alignment of the wooden panel bottoms.
After the front of the wall has been plated (closed) on one side with OSB or other closing materials, the main table lever is actuated so that the wall (panel) is transhipped on the secondary (neighbour) table with the un-plated side up. When working on this wall, to introduce thermal/soundproofing materials, installations, films for vapour/wind barrier, plasterboard closing, OSB etc. a new wall can be assembled on the main table.
Walls with heights between 2.25 m and 3 m can be made